Menu
Cart 0

Raptor Shift Light Install-Ram SRT10

 Raptor Shift Light Install-Ram Srt10Raptor Shift Light Install-Ram Srt10

Raptor Shift Light Install-Ram Srt10 Raptor Shift Light Install-Ram Srt10

The switched power source came from circuit F984 pink/yellow at connector C220 pin #14 under the dash to the left of the clutch pedal.  Ground just went to an IP brace.

Raptor Shift Light Install-Ram Srt10 Raptor Shift Light Install-Ram Srt10 

The tach signal can be picked up at the PCM located in the passenger rear of the engine compartment.  There are 5 different coil driver circuits that can be used all located in the black PCM connector C1 (the bottom connector).  Any one of these can be used...

Pin #1 is circuit K133 dark blue/white for coil control #4

Pin #3 is circuit K18 dark blue/orange for coil control #3

Pin #5 is circuit K134 dark blue/yellow for coil control #5

Pin #7 is circuit K19 dark blue/dark green for coil control #1

Pin #9 is circuit K17 dark blue/tan for coil control #2

Liquid error: Could not find asset snippets/adolab-get-clicked-seo.liquid