Menu
Cart 0

Raptor Shift Light Install-Focus

2002 Ford Focus L4 2.0L DOHC:

Tach: At coil pack. Connect green wire of shift light to either black with green stripe or black with orange stripe. Set shift light to 1 PPR (2 cylinder mode).


You can also get the signal at the PCM located at passenger side kick panel, black wire with green stripe (pin #52 on PCM connector C415) or black with orange stripe (pin #26 on PCM connector C415).

Vss: If you are using a dual mode shift light (launch/shift), connect white wire of shift light to white wire with blue stripe, pin #58 of PCM connector C415.

 

 

2014 Ford Focus ST:

   

Tach: At any ignition "coil on plug" connection. All four ignition coils have 3 wires and two of them are common color on all the coils. Only the coil driver (tach signal)  has an uncommon color on the four coil connectors.

As shown below, connect the green wire of shift light to the white wire with purple stripe on the coil connector.

Ground: Connect black wire of shift light to the green with black stripe wire on the coil connector.

Switched 12 Volts: Connect the red wire of the shift light to the green with white stripe wire on the coil connector.

 

***Do not reverse these wires. Connecting the red wire to a coil driver will damage the shift light***

Set the shift light to 1 PPR (2 cylinder mode).

 

 

 

Vss: