Raptor Shift Light Install-1999-2004 4.6L GT/Cobra V8
Single Mode shift Light Installation Instructions
(for dual mode shift light see additional step at bottom of page)
|
|
Magazine Articles Relating to the 99-2004 Mustang Raptor Shift Light |
**Use red wire taps (22 ga.) here instead of the blue ones shown (18 ga.)
**Use red wire taps (22 ga.) here instead of the blue ones shown (18 ga.)
Set the shift light to "1/2 Pulse/Rev" (1 cylinder mode) since the shift light will read off a single coil
Another popular Mounting Location
If installing a Raptor dual mode shift light (w/launch mode), connect the white wire of the shift light to pin #68 of ECM connector (white wire with orange stripe). This is the vehicle speed output signal from the ECM.