Raptor Shift Light Install-Mustang GT500, 2013-2014 5.8L V8
There are 3 connectors on the PCM:
C175E in middle
C175B on bottom
1) Connect green wire of shift light to coil driver #1:
Pin #70 on PCM, 70 pin connector C175e (middle connector, white wire with violet stripe). **Note**: You can also go directly to the #1 coil for this wire. Or any coil driver will work.
2) Connect red wire of shift light to 12 volts switched source:
Pin #42 on PCM, 70 pin connector C175B (bottom connector)(yellow wire).
It is recommended to use an inline fuse (1/4 Amp if available) for the red wire of the shift light.
3) Black wire of shift light to ground of vehicle or pin #69 on PCM connector C175B (bottom connector), black wire with blue stripe.
4) If installing a dual mode shift light, connect the white wire of the shift light to pin #36 on PCM 50 Pin connector C175t (TOP connector) (brown wire with green stripe). This wire comes from the output shaft speed sensor on the back of the transmission.
Set the shift light to "1 cylinder" mode (1/2 PPR)