Raptor Shift Light Install-Viper

 

 

1992-1995

Engine RPM signal is located at the 34 position ignition control module (ICM) connector. Use one of the coil control signals listed below. ***Do not use the tach out lead from the ECU (signal too weak)***

Pin #3 (coil driver #1)

Pin #1 (coil driver #2)

Pin #12 (coil driver #3)

Pin #18 (coil driver #4)

Pin #10 (coil driver #5)

Set the shift light to 1 pulse/rev (2 cylinder mode)

--->Ignition Control Module Pinout<---

 

1996-1998

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C3 Connector: C2
Connector Color: Black Connector Color: White
Pin#: 7 Pin#: 27
Description: Coil Driver #1 Description: Vehicle speed sensor
Wire Color: Black with gray stripe Wire Color: White with tan stripe

 

1999-2002

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C1 Connector: C2
Connector Color: Black Connector Color: White
Pin#: 7 Pin#: 27
Description: Coil Driver #1 Description: Vehicle speed sensor
Wire Color: Black with gray stripe Wire Color: White with tan stripe

 

2003-2004

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C1 Connector: C2
Connector Color: Black/Black Connector Color: Black/White
Pin#: 7 Pin#: 27
Description: Coil Driver #1 Description: Vehicle speed sensor
Wire Color: Black with gray stripe Wire Color: White with orange stripe

 

 2005-2007

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C1 Connector: C2
Connector Color: Black/Black Connector Color: Black/White
Pin#: 7 Pin#: 27
Description: Coil Driver #1 Description: Vehicle speed sensor
Wire Color: Blue with green stripe Wire Color: Violet with orange stripe

 

 2008-2010

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C2 Connector: C4
Connector Color: Black/Orange Connector Color: Black/Green
Pin#: 1 Pin#: 29
Description: Coil Driver #1 Description: Vehicle speed sensor
Wire Color: Yellow with blue stripe Wire Color: Blue with violet stripe

 ***Note***: In 2008, Dodge went to coil on plug ignition coils. Connect the green wire of the shift light to only ONE of the 10 coil drivers. There are 4 connectors on the ECM (C1, C2, C3 and C4).You can connect at any coil or at the ECM.

***NOTE***: Shift light must be set to "1 cylinder" mode  (1 pulse/2 rev) since it will read off any of the 10 coil drivers

 

 2013-2017

Tach Signal Speed Signal
Location: ECM Location: ECM
Connector: C2 Connector: C3
Connector Color: Orange Connector Color: Natural
Pin#: 1 Pin#: 28
Description: Coil Driver #1 Description: Clutch Upstop Signal (See note 1)
Wire Color: Yellow with blue stripe Wire Color: Green with orange stripe

  ***NOTE 1***: Dual mode shift lights will have to be factory programmed to read from the clutch switch on 2013-2017 Vipers.

***NOTE 2***: Shift light must be set to "1 cylinder" mode  (1 pulse/2 rev) since it will read off any of the 10 coil drivers.