Digital RPM Activated Switch

Our new RPM activated switched is based on the same technology as our shift light. However, it gives you the ability to mount it remotely, hidden and out of site.

 

Dimensions: 2.25" x 2.25".  This can be mounted in the glove box or underneath  the dash to retain the factory look while having all of the benefits of a performance shift light!!

Two relay outputs, one normally open and one normally closed, rated for 2 amps. Use them to turn on or turn off a device at a preset RPM. It can trigger solenoids, our warning light, an LED/resistor assembly, etc. by providing  a ground signal.

	Simply turn the three rotary RPM & cylinder setting switches then cycle the power. The new settings are then stored in the micro-controller's memory. Tach test mode verifies correct tach signal present.
	Shown here with single LED for a very low key shift light installation (LED assembly not included). See below to order.
	Shown here with the Raptor Warning Light for a very compact shift light application (warning light not included).

ORDER HERE

 

 

 

 

 

 

 

Installed

 

 

Two examples of our RPM Switch mounted remotely in conjunction with two LEDs for a low key shift light application.

 

Dodge SRT4

---

05 Nissan Maxima

---